Best Deck Refinishing in Edina, MN
Rough, cracked, peeling boards covered in old flaking finish? Refinishing strips it back, smooths it out, and gives your Edina deck a real surface again.
TL;DR - If your deck boards are rough, cracked, peeling, or covered in old flaking finish, deck refinishing is what you need. JVN Exteriors strips away the old stuff, sands the wood back to smooth, and repairs damaged boards so your Edina deck has a solid surface worth caring for again.
Edina winters are rough on wood decks. By the time spring rolls around, a lot of homeowners are looking at boards that are cracked, splintered, or covered in old finish that's peeling up in chunks. Sometimes the wood underneath is still solid. It just needs real work to get there.
That's deck refinishing.
We do a lot of deck refinishing work across Edina, from older homes in the Morningside and Wooddale neighborhoods where decks have been through 10 or 15 winters, to newer properties near Centennial Lakes where a builder-grade deck finish gave out way too soon. Different situations, same solution: strip it back, fix what's broken, and give the wood a proper surface again.
Stripping Old Deck Finish and Paint Removal
Old finish doesn't just look bad. It traps moisture, hides rot, and makes it impossible for any new treatment to bond properly to the wood.
Before anything else happens to your deck, the old material has to come off. JVN Exteriors uses chemical strippers designed for wood decks, combined with careful mechanical removal where needed. We work down to bare wood without gouging or damaging the boards underneath.
This step takes time. A lot of contractors skip it or do it halfway. We don't. Peeling finish and old paint need to be fully removed or the results won't last, plain and simple.
Homes around the Country Club area and near 50th and France tend to have decks with multiple old coats layered on top of each other. That takes more work to remove, but it has to be done right.
Deck Sanding and Surface Restoration
Once the old finish is off, the real condition of the wood shows itself.
Some boards are smooth and solid. Others are rough, raised, or have splinter patterns from years of weather and foot traffic. Sanding brings everything back to an even, smooth surface that looks good and feels good underfoot.
JVN Exteriors sands decks by hand and with power tools depending on what the boards need. Flat decking boards get a thorough sanding. Railings, trim, and detail areas get careful hand work so nothing gets missed.
This is the step that separates a refinished deck from one that just looks like it got a coat of something slapped on top of old damage. Edina homeowners near Arden Park and Braemar often tell us their deck feels like a completely different surface after sanding. That reaction makes sense. It basically is.
Deck Board Repair and Replacement
While we are stripping and sanding, we get a close look at every board on your deck. That means we catch problems that are easy to miss from a distance.
Soft spots from rot. Boards that have cupped or warped from moisture. Nails or screws that have popped up and create a tripping hazard. Cracked boards that will split completely in one more winter.
We handle repairs as part of the refinishing process. Bad boards get replaced. Fasteners get reset or replaced. Structural issues that need attention get flagged so nothing gets covered up and forgotten.
Your deck should be solid before it looks good, not the other way around.
FAQ: Deck Refinishing in Edina, MN
Ready to Refinish Your Deck?
Book a professional deck refinishing in Edina and start the season with a deck that looks - and feels - brand new.